030-300408 Rev. B
103
August 2005
VersaLink™ Gateway (Model 327W)
User Guide
If you clicked on
OK
in the preceding pop-up screen, the following pop-up screen will appear. VersaLink must be
reset to allow the new configuration to take effect. Click on
OK.
If you clicked on
OK
in the preceding screen
,
the following screen will be displayed. VersaLink will be reset and
the new configuration will take effect.
After VersaLink has been reset, the DSL LED will be OFF. This is because the DSL transceiver has now been
disabled. However, the
Power,
Ethernet
, and
Wireless
LEDs will remain lit.
13.6.3 Editing the WAN Configuration
The following
VC 1 Configuration
screen will be displayed if you click on the
edit
button adjacent to any of the
‘Enabled’ protocols displayed in the
WAN Configuration
screen. (Note: The Protocol must be enabled before you
can edit its VC configuration.) The
VC 1 Configuration
screen allows you to edit your virtual connection (VC). A
virtual connection identifies a connection through the service provider’s ATM network to your ISP. Unlike physical
hardware connections, virtual connections are defined by data.
If you change any of the VC settings in the following screen, click on the
Set VC
button.
NOTE: If you experience any problems, please reset VersaLink via the external hardware reset button or via the
procedure defined under the
Maintenance
menu in section 15.1. The actual information displayed in this screen
may vary, depending on network connection established.
