Wesmar HD800/110-10, Руководство по установке и эксплуатации

Страница: 48 / 100

Page 48
WESMAR
HD800
Thread the jam nut all the way on the soundome tube.
If the Seachest is above the waterline, the threads do not need
to be sealed. For seachest below the waterline, wrap the
threads with tefl on tape or use Permatex Thread Sealant
with Tefl on, Part Number 14H.
WARNING
Do not use bonding compound when threading the soundome
tube into the soundome. Chemicals in the bonding com-
pound will weaken the neck of the soundome.
Run the soundome cable through the soundome tube, starting
at the threaded end.
Screw the soundome tube into the top of the soundome
assembly until it fi ts snugly. Avoid cross threading.
Tighten the jam nut until it also fi ts snugly.
WARNING: Screwing the tube down too tightly can damage
the soundome and/or jam nut.
2.3 6-Inch Soundome
The 6-inch soundome has a FWD arrow molded into the top
of the soundome bell.
This FWD arrow must point forward when the soundome
is installed in the seachest.
Make a mark on top of the soundome tube in line with the
FWD arrow on the soundome bell.
This mark will be your positioning reference point.
2.4 8-Inch Soundome
The 8-inch soundome has an AFT arrow molded into the
top that points to the aft fi n. That fi n, not the arrow,
should point aft.
Make a mark on top of the soundome tube in line with the
AFT fi n of the soundome bell.
This mark will be your positioning reference point.
3.0 ASSEMBLE THE LEAD SCREW
HOIST
Note: The Lead Screw Hoist is shipped in the up
CLEARANCE BETWEEN SOUNDOME AND
SEACHEST
1/16"
1/16"
1/16"
1/16"