Welbilt Convotherm OES mini easyTouch, Руководство по установке

Страница: 86 / 106

7.2 Procedure for putting the appliance into service
Meaning
This section is intended for personnel who will prepare the appliance for first-time use. It summarizes
what requirements must be met prior to putting the combi oven into use, and describes the procedure
for preparing the appliance.
Checks prior to putting the appliance into service
Before preparing the combi oven for first-time use, check that the following requirements are met:
■
The appliance has no signs of damage.
■
The appliance has been set up so that it cannot slide about or tip over; the requirements for the
installation position and the area around the appliance have been met (see section Appliance on
page 42).
■
Protective films, cardboard packaging and transport securing devices etc. have been removed
completely.
■
The cooking chamber contains no stored items or food nor any equipment other than necessary
cooking accessories (e. g. food containers).
■
The appliance is installed in accordance with the requirements in the chapter Installation on page
60.
Use the checklist for moving, setting up and installing the appliance on page 100 to carry out these
checks.
■
The appliance was subjected to an individual electrical test (see below).
■
All safety devices are in their designated position and are working correctly.
All warning signs are in their designated position.
Use the Safety devices and warnings checklist on page 102 to carry out these checks.
The appliance must not be put into operation until all the specified requirements are met.
Individual electrical test
The individual electrical test comprises the following three steps:
■
Observation: Visual inspection for damage or improper use
■
Measurement: Carry out prescribed measurements in accordance with accepted engineering
standards (protective earth resistance, insulating resistance, protective earth current / leakage cur‐
rent)
■
Testing: Functional test
The individual electrical test must be repeated regularly in accordance with the legal regulations.
Putting into service (6.06/6.10/10.10 mini)
To prepare the combi oven for first-time use, follow the steps below:
Step Action More on this ...
1
Bring the ambient temperature to the permitted operat‐
ing temperature.
2
Switch on the circuit breaker.
3
Open the water supply.
4
Check that the following are seated properly and in the
correct position:
■
Suction panel
■
Racks
See user manual
5
Switch on the combi oven. See user manual
6
Set the following:
■
Date
■
Time
■
Language
See user manual
7 Putting into service
Installation manual 86