© 2022 WEINZIERL ENGINEERING GmbH
Seite 18/36
11.1 General settings
Device name
(30 characters)
An arbitrary name can be assigned for the KNX RF / ENO Push Button 440
secure
. The device
name should be meaningful, e.g. “Living Room”. This helps the clarity of the ETS project.
Prog. mode (press A0+B0 for 6 sec.)
In addition to the normal programming button
❷
the device allows activating the programming
mode on the device front without removing the rocker. The programming mode can be activated
and deactivated via pressing simultaneously both buttons
❸
and
❺
for 6 seconds.
This feature can be enabled and disabled via the parameter “Prog. mode (press A0+B0 for 6
sec.)”. The recessed programming button
❷
is always enabled and not influenced by this
parameter.
The prog. mode (A0+B0) should be deactivated if push button functions are configured for
actuations of more than 6 seconds (e.g. moving shutter via deadman switch)
Battery state cycle time
Sends the battery state good (1) or low (0) cyclically to the KNX bus. For the cycle time values
between 1 h and 24 h are selectable.
Group object
Type KNX
Size
Direction
GO 1 Battery state
– State good
1.001
1 Bit
To KNX
Long button press after
Here you can set the time for detecting a long actuation, this time is valid for all buttons.
