11
13. Wet a Squat Arm (18) and the inside of a Small
Foam Pad (36) with soapy water. Slide the Foam
Pad onto the Squat Arm.
Grease an M10 x 73mm Bolt (137). Attach a
Squat Arm (18) to the Squat Carriage (10) with
the Bolt, two 24mm Plastic Washers (110), and
an M10 Nylon Locknut (112).
Do not overtighten
the Locknut; the Squat Arm should be able to
pivot with intermediate effort.
Repeat this step with the other Squat Arm
(18).
110
112
110
13
137
Grease
10
18
36
18
14. Orient the Top Frame (20) with the mark in the
position shown. Attach the Top Frame to the
Upright (3) with two M10 x 65mm Button Screws
(117) and two M10 Washers (129). Press the
Plastic Cap (46) into the Upright, over the Top
Frame.
14
46
20
117 129
3
Mark
16. Attach the Console (21) to the Upper Wire
Harness (172).
The connector should slide easi-
ly into the socket and snap into place.
If a con-
nector does not slide easily and snap into place,
turn it over and then insert it.
IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Push the excess wire into the
Upright (3).
Attach the Console (21) to the Upright (3) with
two M4 x 80mm Self-tapping Screws (145), two
M4 x 65mm Self-tapping Screws (158), and four
M4 Washers (157).
16
172
21
157
3
158
145
157
15. Attach the Upright Plate (23) to the Upright (3)
with six M4 x 9mm Self-tapping Screws (106).
15
106
23
3
106