14
24. Insert the two Short Pad Tubes (32) into the Leg
Lever (13). Slide two Large Foam Pads (37) onto
each Short Pad Tube.
Repeat this step with the Long Pad Tube (153)
and the Front Leg (4).
23. Route the short end of the Split Cable (72)
through the Front Leg (4) and attach it inside the
Leg Lever (13) with a Leg Lever Pin (91) and a
Cotter Pin (90).
Attach a 90mm Pulley (92) inside the Front Leg
(4), over the Split Cable (72), with an M10 x
92mm Bolt (116), two M10 Washers (129), two
25mm Spacers (130), and an M10 Nylon Locknut
(112).
23
24
13
72
91
90
4
129
129
112
130
92
72
130
32
32
153
4
37
13
37
116
25. Attach the Backrest Cap (40) to the Backrest
Frame (17) with two M4 x 16mm Self-tapping
Screws (104).
Attach a Bumper (168) to the Backrest Frame
(17) with an M4 x 16mm Self-tapping Screw (104)
and an M4 Washer (157).
Attach the Right Pinch Guard (42) to the Backrest
Frame (17) with two M4 x 9mm Self-tapping
Screws (106).
Attach the Left Pinch Guard (41)
in the same manner.
25
41
42
17
106
168
157
104
40
104