6
Before beginning assembly, carefully read the
following information and instructions:
•
Assembly requires two persons.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
•
For help identifying small parts, use the PART
IDENTIFICATION CHART.
Note: Some small
parts may have been pre-attached for shipping. If
a part is not in the parts bag, check to see if it
has been pre-attached.
•
Tighten all parts as you assemble them, unless
instructed to do otherwise.
•
As you assemble the resistance system, make
sure all parts are oriented as shown in the draw-
ings.
The included hex keys and the following
tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the resist-
ance system can be assembled successfully by
most people. However, it is important to realize
that the versatile resistance system has many
parts and that the assembly process will take
time. Most people find that by setting aside plenty
of time, assembly will go smoothly.
ASSEMBLY
1
1.
Attach four Plastic Base Feet (71) to the Base (1)
with four M4 Washers (157) and four M4 x 16mm
Self-tapping Screws (104).
Attach a Wheel (49) to the Base (1) with an M8 x
90mm Shoulder Bolt (125), two M8 Washers
(152), and an M8 Nylon Jamnut (139).
Repeat
with the other Wheel.
Before beginning assembly, make sure that
you have read and understand the informa-
tion in the box above. Refer to the PART
IDENTIFICATION CHART for help identifying
small parts.
1
104
157
71
49
49
104
139
152
152
125
157
71
104
157
71
104
157
71
