9
9
8
3
10
3
35
31
2
105
129
159
172
172
173
9.
Press the Front Cover (31) onto the Upright Base
(2).
Make sure the Cover is oriented as shown
in the inset drawing.
Route the Upper Wire Harness (172) down
through the Upright Base (2) and out the large
round hole in the back, as shown.
Slide the Upright (3) onto the Upright Base (2).
Make sure you do not pinch the Upper Wire
Harnesses (172).
Secure the Upright with two
M10 Washers (129), two M10 x 20mm Screws
(113), and two M10 x 25mm Screws (105).
Do
not tighten the Screws yet.
Connect the Upper Wire Harness (172) to the
Lower Wire Harness (173) extending from the
Mech Frame (not shown).
The connector should
slide easily into the socket and snap into place.
If the connector does not slide easily and snap into
place, turn it over and then insert it.
IF THE CON-
NECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Press the excess wire
into the Upright Base.
Tighten two M4 x 16mm White ZP Self-tapping
Screws (159) into the Upright (3).
113
8.
Slide the Squat Carriage (10) onto the Upright (3)
as shown. Insert the Squat Pin (35) into an upper
hole in the Upright.
159
31
