14
Fusing a Fitting
(continued)
t1MBDFQJQFBHBJOTU53*50/'JUUJOHNFB
-
surement guide (located on each Fitting)
and make small scratch using thumbnail
or line with pencil to mark for insertion
depth as shown (B). Orient Fitting (as
needed) and insert pipe into Fitting to
required depth.
Activate Fuser
t-PDLUIF'VTFSKBXTBSPVOEUIFBTTFNCMZ
by depressing the lever tongue.
t%FQSFTT'VTFSCVUUPOGPSTFDPOETBOE
release to initiate fusing process.
B
C
D
Note: The Control Unit automatically senses ambient temperature and will
automatically adjust the fusion time as necessary.
Note: Each Fitting is designed so that the Fuser jaws will only fit on the assembly
and close in the correct position on the weld zone.
t*OWFSU'VTFSQPTJUJPOBTOFDFTTBSZUP
accommodate for tight spaces.
Failure to insert pipe into Fitting
to required depth will produce an
improper joint which can result in
leaks. Such leaks may even exist
BGUFSQSFTTVSFUFTUJOHQPTTJCMZ
causing property damage.
Unpack Fitting carefully and check
for any shipping or transportation
damage. Do not use Fitting if any
damage is found—repackage Fitting
and return it to purchase place for
repair or replacement.
t0QFOKBXTPO'VTFSCZTMJEJOHUIVNC
under lever tongue (C) and pushing
upwards.
t"UUBDI'VTFSUP'JUUJOHBTTIPXO %XJUI
jaws properly positioned in weld zone.
NOTICE
NOTICE
Prepare Fitting for Fusion
Equipment Setup & Usage Instructions
STEP 2
STEP 3