31
Temperature Measurements
The processor's temperature sensor is located on the face plate (See page 8). The temperature
sensor does not respond immediately to thermal changes. In order to ensure accurate ambient
temperature measurements, the processor should be left in the fitting environment for at least 15
minutes. Direct exposure to sunlight and other heat sources will adversely affect accuracy.
Low Ambient Temperature Warning
**This section applies to the
RF-3000LE Electrofusion Processor
only.
Fusions performed in ambient temperatures less than 50°F may require additional preparation and
instruction. If you attempt to perform a fusion in an environment where the ambient temperature is
below 50°F, the
RF-3000LE Electrofusion Processor
will display the following message:
If the processor displays this message, please consult Orion Engineering Department at
910-865-
7530
for preheat instructions before proceeding with the fusion.
WARNING 53 RECEIVED
Low Temp Advisory
Call Orion Eng
Press START to clear