Waters 2414, Обзор и руководство по обслуживанию

Страница: 36 / 130

June 11, 2015, 715004754 Rev. A
Page 36
2.2.1 Unpacking
To unpack the detector:
1. Check the contents of the shipping cartons against the packing lists to ensure
that you received all items.
2. Save the shipping cartons for future transport or shipment.
2.2.2 Inspecting
If you discover any damage or discrepancy when you inspect the contents of the
cartons, immediately contact the shipping agent and your local Waters
representative.
Customers in the USA and Canada can report damage and discrepancies to Waters
Technical Service (800 252-4752). Others can phone their local Waters subsidiary or
Waters corporate headquarters in Milford, Massachusetts (USA), or visit
www.waters.com.
For complete information on reporting shipping damages and submitting claims, see
Waters Licenses, Warranties, and Support Services .
Note:
Ensure that the serial number on the detector’s rear panel nameplate or inside
the front left-hand panel matches the number on its validation certificate.
2.3 Selecting a laboratory site
Install the 2414 RI detector in an area that meets the requirements listed in the table
below.
Requirement:
You must mount the detector on a level surface to allow proper
function of the drip management system (drain tube), which you can connect to a
waste reservoir.
Table 2–1: Installation site requirements
Parameter Requirement
Operating temperature range 15 to 40
°
C (59 to 104
°
F); avoid direct exposure
to sunlight and heating and cooling vents.
Operating humidity range 20 to 80%, non-condensing
Shipping and storage
temperature range
–30 to 60
°
C (–22 to 140
°
F)
Shipping and storage humidity
range
20 to 85%, non-condensing
Bench space 12.7 cm (5 inches) clearance at rear
Static electricity
<
8 kV contact
Power Grounded AC, 100 to 240 Vac, 50 to 60 Hz