W&T 57630, Руководство пользователя

Страница: 28 / 211

28
W&T
Connections, operating elements and LEDs
3.5 LEDs for device status
Power-LED:
Indicates the presence of supply voltage. If the LED does not come
on, check the power supply connections.
Status-LED:
Blinks whenever there is network activity with the Web-IO. Periodic
blinking indicates that the port has a connection to another station.
Error-LED:
The Error-LED uses various blinking codes to indicate error states
on the device or network port.
1x blinking of the Error-LED
Check network connection. The Web-IO is not getting a link pulse
from a hub/switch. Check the cable or the hub/switch port.
2x or 3x blinking of the Error-LED
Press the button on the housing to perform a reset. If this does
not clear the error, reset the device to its factory defaults. Since
this resets all network settings, you should write down your
settings first.
Web-Based Management: Config >> Session Control >> LogOut
>> Restore Defaults . Following a reset the device is restored to
its factory defaults. Reconfigure your network settings.
i
More information about menus and coniguration can be
found in the section Web-Based Management.
on error http://xxx.xxx.xxx.xxx/diag-LED:
Indicates internal configuration errors. For troubleshooting, go to
page http://<IP address of the Web-IO>/diag in the unit.