W&T 57630, Руководство пользователя

Страница: 209 / 211

209
W&T
Error messages
Subject to errors and modifications:
Error message Possible cause
UDP port number invalid: use Port 42279 Duplicate assigned port number, port number greater than
65535 or text given instead of digits for port number
Checksum error: factory defaults were loaded ROM error detected in configuration area
SNMP: IP address or name of Snmp manager not
entered see Config >> Device >> Alarm >> Alarmx >> SNMP
UDP alarm: IP address or name of UDP server not
entered see Config >> Device >> Alarm >> Alarmx >> UDP
UDP alarm: Port of UDP server not entered see Config >> Device >> Alarm >> Alarmx >> UDP
Number of pulses exceeds 2000/sec: pulse mode input
x stopped! Input signal frequency too high
50xxx-Mode: Invalid UPD IP address see Config >> Device >> Mode 50xxx >> UDP Client
50xxx-Mode: Invalid TCP IP address see Config >> Device >> Mode 50xxx >> TCP Client
Watchdog timer expired Safety watchdog detected no network traffic within the
specified timeout time and the outputs were set to Safety
State
Box2Box: Invalid port number Port number greater than 65535 or text entered instead of
digits for port number. Config >> Device >> Box 2 Box
Box2Box: Invalid slave IP address No IP address specified or invalid address format. Config
>> Device >> Box 2 Box
Port number assigned more than once Each mode must use a unique port number (see Appendix
7 Port Number List)
50xxx: Invalid local port number Duplicate assigned port number, port number greater than
65535 or text entered instead of digits for port number.
Config >> Device >> Mode 50xxx
Box2Box: Invalid local port number Duplicate assigned port number, port number greater than
65535 or text entered instead of digits for port number.
Config >> Device >> Mode Box2Box
Box2Box: Slave access denied, please check Box2Box
settings Slave many be in Operator or Administrator Login, slave
working in 50xxx mode or is blocked by another mode.
Box2Box: Slave is in Box2Box Master Mode see Config >> Device >> Box 2 Box for Slave Web-IO
Box2Box: Master could not be cleared, please log out Slave is in Operator or Administrator Login and could not
clear the master connection data
Overload: Details under Diag>>Test>OutputConfig An overload or no load was detected on one or more
outputs
Restart using Delete report After a load error the corresponding output is enabled
again using Delete report.
After an error caused by high-frequency input signals,
pulse mode is activated again after Delete report.