6.0
6.0 INFORMATION REGARDING USE
WAMFLO
®
FN200X
2
FIL.WAMFLO_FN200.EX.M.A7.0522.EN Issue: A7
05.22
48
6.3 Long shut-downs of the equipment
When the equipment has to remain unused for long periods, proceed as described below.
1)
Avoid damp and salty environments during equipment shut-downs.
2)
Place the equipment on wooden pallet.
3)
Set the equipment in safety condition before operating it.
4)
Before using the equipment, check the condition of the electrical and pneumatic systems and all the parts
the working of which may be affected by prolonged shut-downs.
5)
Run a complete cleaning cycle before activating the filter.
6.4 Reuse after long shut-down
Important
If the equipment is to be used in different conditions and with materials other than the previous applica
-
tion, ensure the “Permitted use” indications are complied with.
Before reusing the filter after a long shut-down, proceed as described below:
1)
Check the main nuts and bolts to make sure they are tightened properly.
2)
Check all oil levels.
3)
Start up the equipment (see “Production Start-up”).
6.2 Machine shut-down at the end of the work cycle
1)
Shut down the filter without disconnecting it from the power supply (according to the settings of the board,
the end of cycle cleaning gets automatically enabled on the basis of the number of cycles pre-configured
on the electronic board.
2)
At the end of the cycle, disconnect the control panel from the power supply.
3)
Shut down the air compressor.
4)
Start up the dust discharging equipment or screw conveyor (if provided).
