6.0
6.0 INFORMATION REGARDING USE
WAMFLO
®
FN200X
2
FIL.WAMFLO_FN200.EX.M.A7.0522.EN Issue: A7
05.22
47
6.1 Production Start-up
Before starting up the filter, the operator in charge and authorized for the production must ensure the safety
devices installed are present and working and the operating conditions are followed (hatches closed, inlet and
outlet spouts connected correctly o protected,etc.).
Start up procedure
After having completed the preliminary checks, carry out the start up procedure as follows:
1)
Start up the dust discharging equipment (if provided).
2)
Start up the air compressor.
3)
Power up the electronic board (MS LED On).
4)
Start up the cleaning cycle (CLEAN led On).
5)
Make sure all the solenoid valves work correctly (the yellow led lights up when the board sends the pulse
to the solenoid valve).
6)
Check the blow duration and the interval between one blow and the next.
N.B.: If the filter features a FILCONTROL CONNECT electronic board, in case the solenoid valves are
not acknowledged, the board displays the message ERR01.
Danger - Warning
When a fan is installed, in the initial phase of filter use, the air capacity must be adjusted to the de
-
signed value.
When the pressure losses are balanced, the air flow value has to be adjusted again. Then ensure the
power absorption does not exceed the value on the rating plate.
Once the filter is installed, it is necessary to check the cleaning cycle,
especially in the first few weeks of
operation.
Only through these checks it will be possible to determine whether the preset pause duration is the proper one
as regards the cleaning of the filter cartridges.
- After a few hours of operation, ensure the vibrations have not slackened the nuts and bolts.
- Avoid consecutive start-ups of the motor as it involves continuous overloads leading to overheating of the
electrical parts. Before restarting leave it to cool sufficiently.
- Be reminded that
WAM
®
fans are fitted with their own sealed single-block bearings, unless otherwise speci
-
fied by the Customer and therefore do not need any checking of the lubrication.
- Once the filter is installed, it is necessary to check the cleaning cycle especially in the first few weeks of
operation.This has to be done to ensure that the pause time setting is sufficient for a correct cleaning ac
-
cording to the Customer’s requirements.
Important
In case of excessive noise, strong vibrations, etc. stop the equipment and report the problem
to the person in charge authorized to restore the correct working.
Do not use the equipment if damaged.
