![background image](http://html2.mh-extra.com/html/waltco-lift/bz-33/bz-33_installation-manual_3269133035.webp)
Chapter 4 Liftgate Installation
INSTALL REAR SILL EXTENSION
Cut extension so it will extend to within ½” of each side
to vehicle body.
Position and weld extension, centered on door opening.
Note
: If the full door seal kit, or flip-up door option are to
be used, they will use a different type of sill extension.
Note
: For vehicles with swing doors, refer to the section
in the back of this chapter “Swing door application”.
GR00086
POSITIONING OF PLATFORM
Using the raise switch, raise lift arms up off the ground
as shown.
Lift Platform Using an Over-Head Crane or Forklift as
shown.
Other means may be used to support the
platform in position. ALWAYS verify the
safety of your supporting method before
proceeding.
GR00087
INSTALLATION OF LIFT ARMS
Align the Lift Arms with the upper holes in the Platform
Hinges.
Pin the Lift Arms to the Platform Hinges as shown.
Secure pins with lock nuts.
GR01762
Pin tang to fully engage in
hole of platform hinge
(middle plate)
Platform hinge
(outer plate)
Platform hinge
(middle plate)
Platform hinge
(inner plate)
page 35
Содержание BZ-33
Страница 17: ...Chapter 4 Liftgate Installation Electric and Hydraulic Diagram G page 17...
Страница 18: ...Chapter 4 Liftgate Installation Electric and Hydraulic Diagram with Auto tilt G page 18...
Страница 61: ...Add silicone caulk to seal gaps between tracks and vehicle body page 61...
Страница 65: ...This page left intentionally blank page 65...