Waltco Lift BZ-33, Руководство по установке

Страница: 56 / 66

BATTERY KIT INSTALLATIONS
80101387
EO6410 Rev 04
7-22-10
INSTALLATION OF CIRCUIT BREAKER(S)
Auxiliary batteries on a truck will require circuit breakers
at both the auxiliary batteries and the vehicle batteries.
Locate and mount 150 Amp circuit breaker directly to
batteries using copper terminal link supplied.
Circuit breaker must be mounted to give good protection
against any objects coming into contact with circuit
breaker terminals and causing a short. Position must
also be readily accessible to reset breaker.
Note: Circuit Breaker is to rest solidly on battery to
prevent vibration during transit.
If unable to connect circuit breaker direct to batteries, an
optional 24”, maximum length, 2 Ga. battery cable may
be used.
Connect end of battery cable from liftgate to Terminal
Link attached to circuit breaker.
Apply a generous amount of Dielectric Grease to all
Positive (Hot) Battery terminals and Circuit Breaker
terminals.
Secure all battery cables to chassis frame with cable ties
provided.
NOTE: Original equipment ground cable furnished
on vehicle should be at least a number 2 ga. to
insure proper operation of pump unit. An auxiliary
ground cable should be added between engine
block and chassis frame if engine is not adequately
grounded to chassis frame. When there are two or
more batteries, all cables connecting batteries
together must be 2 ga. or heavier. This includes all
original equipment batteries on vehicle.
Protect wires from any sharp edges or
holes that may abrade insulated covering
of wires.
Secure battery cable so it does not come
near, or in contact with, other vehicle
wiring, fuel lines, brake lines, air hoses,
exhaust system, etc.
GR01413
150 Amp
Circuit Breaker
Cable supplied
with Liftgate
See below
For detail
Cable supplied with
Liftgate or with Trailer
Kit
Ground
Cable
Cable to Vehicle Batteries
or to Nose of Trailer
Terminal Links
Cable from Liftgate
page 56