wallas Spartan, Инструкция по установке, эксплуатации и обслуживанию

Страница: 52 / 109

- 50 -
Maintenance recommendations
Service recommendation for the heater is about 5000 operating hours, depending on the fuel used.
Maintenance should be carried out by authorized Wallas service shop.
Protect the water system from freezing conditions. See detailed instructions below (winter storage).
Special recommendations
Monthly use of the device will increase reliability by purging old fuel.
Observe fuel provider recommendation with regard to the fuel type, fuel life lenght, additives and moisture removal.
If the device has a separate tank:
When selecting the fuel type, take note of the temperature limits of each particular fuel.
Removal of the water from the tank
Isopropanol based anti ice detergent meant for gasoline cars (no ethylene or methyl based) can be added to the
fuel during the season. It is useful to make the addition after each couple of tanks and in the beginning and end of
the heating season. The anti ice detergent binds the condensed water and prevents the sediment and
contamination during the summer. For the dosage, observe the recommendations given by the manufacturer of the
agent.
Winter storage
If the device uses the same tank as the engine:
• Change the fuel filter.
• Perform measures recommended by the boat/engine manufacturer to be performed before winter storage.
If the device has a separate tank:
• Drain the fuel tank in the autumn.
• Clean the tank and change the fuel filter.
• Fill the fuel tank with fresh and clean fuel in the spring.
For the device itself, you do not need to do anything.
The fresh water should be emptied during freezing conditions. The emptying process should be done by pushing
compressed air to the fresh water pipes for winter. The coolant is not needed and not recommended to be changed
for the winter. Follow the instructions of the coolant manufacturer's change interval.
Spare parts
Spare parts list, www.wallas.com
An anti-freezing agent for diesel vehicles may increase the forming of scale at the bottom of the
burner and therefore shorten the maintenance interval.