wallas Spartan, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 109

- 25 -
Fixed tank connection 30011
Installation instructions for tank connection 30011
1. You will need to make a Ø 25 mm (1") hole in the upper surface of the fuel tank. Choose the location of the hole so
that when the fuel tank tilts the end of the intake pipe will stay in the fuel even if the tank is not full. If the end of the
intake pipe does not reach the fuel, the device will quickly choke on the air in the fuel system and that can cause
malfunction to the system.
2. Cut the fuel intake pipe (Ø 3.2/0.8 mm) to the appropriate length. The end of the pipe must not touch the bottom of
the tank in order to keep water and sediment from the system. It is recommended to cut the pipe short enough to
leave the engine intake pipe at a lower level. This way the device cannot empty the tank.
3. Install the pipe straight end first and angle the two "ears" at the bottom of the threaded barrel inside the hole and
then align the threaded barrel vertically so the ears are hooked on the underside of the tank top. Carefully slip the
rubber washer over the bent pipe end and over the threaded barrel, followed by the metal washer and the nut. Thread
the nut to the threaded barrel and tighten, sealing the fitting to the top surface of the tank.
If the device uses the main tank of the boat, note that the device cannot take the fuel from the same fuel
output line as the engine of the boat.