- 30 -
Tank connection 30018
Einon®
(30018) is a leak-proof intake fuel line.
Getting Started
Parts needed in installation are put in right order and are connected together with a wire. You shall never cut the
installation wire, you’ll need it when installing the intake pipe. (Installation without the wire is not possible).
Installation instruction for 30018 (camper installation)
1.
Make sure that the fuel tank is empty enough.
2.
Search about 4 cm flat section from the fuel tank where
you can drill a 13 mm diameter hole.
3.
Clean the selected area of protection grease and clean
also other possible dirt.
4.
Drill a hole.
5.
Remove the burr from hole (inside and outside).
6.
Figure out without installing for Einon ®
(30018)
suitable
bending and length.
7.
Cut the pipe end diagonally and remove burrs.
8.
Install the cut and bent intake pipe through the drilled
hole into the tank.
9.
Push through the hole into the tank all the other interior
parts (up to the mark), keep the order of parts as they are
mounted to the wire.
10.
Pull from the wire until the Einon ®
(30018)
threaded
part is outside of the tank.
11.
Turn the Einon ®
(30018)
to the correct position and
tighten the tank external part (nut).
12.
Attach the fuel line to the Einon ®
(30018)
.
For camper installation only! Materials are not stainless steel.
Содержание Spartan
