Waldorf QUANTUM, Руководство пользователя

Страница: 156 / 231

Additional Modes
156 Quantum Manual
the Step Length parameter. Up to 32 blocks/steps are
possible. Tap on a step to select it (it lights up in red).
Move your finger up and down to change the pitch of
the selected step. Move your finger from left to right or
vice versa to ‘draw’ a sequence.
•
Above the graphic you find the same number of blocks.
Each block represents a step. Tap on a desired block to
mute the corresponding step, and tap again to unmute.
The selected block lights up in red and displays the
current pitch (e.g. +3).
•
For more accurate editing of a selected step you can
use the Pitch parameter.
•
To get a better view you can divide the graphic into
two sections, from 1-16 and 17-32, if desired. Tap on
the corresponding button above the graphic.
•
Depending on the selected step overview, the blocks
can display pitch, velocity, gate (note length), or one of
the four modulation parameters.
Bpm
Sets the overall tempo for the Arpeggiator and the Se-
quencer in Bpm (beats per minute). This tempo also affects
the functions that may depend on tempo settings (e.g.
LFOs, Komplex Modulator, Delay effect).
Step Length
Determines the rate at which notes are triggered – that is
to say, the speed at which the sequence is running. In addi-
tion to the
Bpm parameter this gives you further control
over the playback speed. You can specify a value in frac-
tions of beats. For example, if
Step Length is set to 1/8, the
sequence plays eight notes per measure.
Swing
Determines how much the timing affects a sequence step.
If
Swing is set to 0.50, the sequence is played back without
any shuffled timing. Settings from 0.51 to 0.95 increase the
shuffling of the notes and create a typical swing. You can
also use settings below
0.50 to influence the timing.
Pitch/Velocity/Gate/Param 1 - 8
This parameter depends on the setting of the Notes button
above the graphic. If
Notes is selected, Pitch is shown and
you can set the pitch for the selected step. If Velo is
selected, you can edit the velocity for the selected step. If
Gate is selected, you can edit the gate length for the selec-
ted step. If Param 1...8 is selected, you can edit the modula-
tion signal for the selected step.