Wake N Grill Page 13
land so it is easier when out on the water. You
should become familiar with the “feel” as you
probably won’t be able to visually see the pin
when the boat is in the water.
THIS COMPLETES ASSEMBLY OF THE UNIVERSAL KIT
Installation of Umbrella Arm (Op-
tional):
Step 1: Locate Parts.
Unwrap and inventory the
following parts in preparation for assembly:
Umbrella Arm Assembly (WNG-Umb-Arm)
1.
1/4”-20 X 3/4” Flat Head Cap Screws (QTY 2)
2.
Step 2:
Positioning Umbrella Arm.
Locate the
three threaded accessory holes along the rear
edge on the underside of the Mounting plate,
WNG-GRL-PLT. These holes allow the Umbrella
Arm to be mounted extending to either the right
or left side of the grill depending on preference.
See Figure 27 “Optional” section.
Step 3:
Secure Umbrella Arm.
Apply Loctite 243
threadlocker (included) to the threads of (2) 1/4-
20” X ¾’ Flat Socket Cap Screws and install the
Umbrella Arm into the selected position on the
underside of the Mounting Plate. Tighten screws.
HINT:
We suggest the Umbrella Arm be mounted
to the right side of the Grill Plate. This will
position the Arm on the same side as the grill
regulator and will allow more room inside the
storage bag for additional supplies.
THIS COMPLETES ASSEMBLY OF THE UMBRELLA ARM
[6RFNHW
+HDG&DS6FUHZ
8PEUHOOD$UP
[)ODW
+HDG&DS6FUHZ
;
8PEUHOOD3OXJ
[6SULQJ3LQ
),1
/2&:DVKHU
;
:Q*),1/2&
0RXQWLQJ3ODWH
[6RFNHW
+HDG&DS6FUHZ
*ULOO3OXJ
2SWLRQDO
Install Pull Pin
Figure 27.
