Wake N Grill Page 12
Assembly and Installation of the
Mid Arm:
Step 1: Locate Parts.
Unwrap and inventory the
following parts in preparation for assembly:
Mid Arm Assembly (WNG-Mid-Arm)
1.
1/4”-20 x 3/8” Smooth Head Cap Screws
2.
(QTY 2)
Step 2:
Position Mid-Arm.
Pick two adjacent
holes and temporarily install the two Smooth
Head Cap Screws into the Mid-Arm Assembly
as shown in
Figure 25
. Hole position is not
important and will be adjusted in the following
steps. Install Mid-Arm Assembly into the Lower
Tube (WNG-LWR-TB) by pulling out the Pull-Pin
(WNG-PULL-PIN) and rotating 90 degrees to lock
in the
open
position.
See Figure 25.
Slide the Mid-Arm Assembly into the Lower Tube
until the screw heads seat into the locating slots
on the Lower Tube. The depth (or overhang) can
be adjusted by moving the two smooth head Cap
screws to different positions within the range
of threaded holes located on the Mid-Arm tube.
Each position changes the depth by 1-1/2” (5
positions for a total range of 6”).
See Figure 25
and 26.
HINT:
Choose a position that will still provide
enough space on the swim platform once the grill
and cutting board are set up. This position can be
changed at any time off the water by moving the
Position Screws.
Once the desired position is found, remove the
two smooth head Cap Screws and reinstall after
applying Loctite 243 threadlocker (included).
Tighten screws. DO NOT overtighten.
Step3:
Check Position.
Test the new position
setting by sliding the Mid-Arm Assembly back into
the Lower Tube. The Pull-Pin should still be in the
open position (if not, pull and rotate the Pull-Pin
shaft 90 degrees to open).
Slide the WNG-Mid-Arm in until the screw heads
seat into the locating slots on the Lower Tube.
See Figure 26.
NOTE:
The locating screws are necessary to
assist with blind installation on the water, they
must be installed for ease of use.
Rotate the Pull-Pin shaft 90 degrees to lock it
in the
closed
position to ensure the Mid-Arm is
locked into position with the Pull-Pin. Usually you
will feel or hear the pin engage into the hole of
the Mid-Arm.
Give the Mid-Arm a tug to make sure it is locked
in and cannot slide out of the Lower Arm.
HINT:
Practice this procedure (Step 3) on dry
0LG$UP$VVHPEO\
6ZLP6WHS
/RZHU7XEH
$VVHPEO\
3XOO3LQ
3XOODQG7ZLVWWRORFNRXW
[
HDG
[6+&6
$GMXVWDELOLW\
5DQJH
Install Pull Pin
Figure 25.
3XOO3LQ
3XOODQG7ZLVWWRORFNRXW
[
HDG
[6+&6
/RFDWLQJ6ORW
Install Pull Pin
Figure 26.
