WAGNER TwinControl, Оригинальное руководство по эксплуатации

Страница: 12 / 132

12
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
2.4 PROCESSIBLE WORKING MATERIALS
Low-viscosity to high-viscosity 2K lacquers (e.g., epoxy, PU, DD) with a pot life of more than 5 minutes.
- 2K water-based priming
- 2K epoxy priming
- 2K solvent-based priming - 2K epoxy lacquers
- 2K PUR priming - 2K high-solid priming
- 2K PUR lacquers - 2K high-solid lacquers
- 2K products with acidic hardeners (only with TwinControl systems for acidic hardeners)
Solvent and water-based 2K products should not be processed using the same system.
Materials in direct contact with the products
: see Chapter 5.5.1
NOTICE
Abrasive working materials and pigments!
Greater wear of product-wetted parts.
Do not use any grainy and abrasive working materials with large, sharp-edged
pigments.
Use application-oriented pumps (flow rate/cycle, product, valves, etc.).
Check if the fluids and solvents used are compatible with the pump construction
materials.
For explanations of the models and construction materials, consult the technical
data in Chapters 5.5.4 / 5.5.5 as well as the operating manuals for the pumps and
valves or contact a WAGNER service technician.
Wear caused by abrasive working materials is not covered by the warranty.
TwinControl for acidic hardeners
Check products for compatibility:
see Chapter 5.5.1
Parts made of stainless steel 1.4404 are
labeled with "1.4404" (see example).
1.4404
B_07123
Designation "1.4404"
Example of hardener pump
WARNING
Acidic hardeners!
Risk of burns and injury for skin, tissue and organs.
Observe the lacquer manufacturer's safety data sheets and take prescribed safety
measures.
2.5 MISUSE
Misuse can lead to physical injury and/or property damage!
Special attention must be paid that:
no dry coating products, e.g. powder are processed;
no food, medicine or cosmetics are processed.