WACO YMF F5 Series, Руководство по обслуживанию

Страница: 39 / 401

YMF WACO F5/F5C SCHEDULED MAINTENANCE WORKSHEET
TASK DESCRIPTION
5
0
H
R
1
0
0
H
R
A
N
N
U
A
L
M
E
C
H
A
N
I
C
I
N
S
P
E
C
T
O
R
C.
COCKPIT/ ELECTRICAL/ RADIO/ INSTRUMENTS - For detailed
instructions see WACO Classic Aircraft Service Manual
1
Inspect front cockpit door and pilot's step door for condition and
operation
0 0
2 Inspect front and rear windshields for condition and security 0 0 0
3 Inspect upholstery for condition and cleanliness 0 0 0
4
Inspect seats, belts and harness and attachments for operation,
condition and security
0 0
5 Check stabilizer trim for smooth operation and security 0 0 0
6
Inspect rudder pedals and brake cylinders for condition, security and
operation
0 0
7 Inspect brake hoses, lines and fittings 0 0
8
Check operation, condition and security of the parking brake valve
installation
CAUTION: It is very important to refer to the Airplane Flight
Manual Section V, Normal Operating Procedures, for instructions in the
correct operation of this control. Failure to follow correct procedure can
result in damage to the parking brake control system and subsequent
unintentional parking brake application during flight operations!
0 0 0
9
Inspect control stick and torque tube assy for operation, condition
and security and for free movement to control limits
0 0
10 Check all engine and flight controls for proper operation 0 0 0
11 Check landing, navigation, cockpit and instrument lights 0 0 0
12 Check pitot heat for operation 0 0 0
13
Check pitot/static systems condition of Pitot tube, static ports and
plumbing
0 0
14 Inspect all instrument mounting, lines and attachments 0 0
15 Certify altimeter system if appropriate 0 0
16 Certify pitot system if appropriate 0 0
17 Carry out Compass swing
18 Check compass card valid until next check
0 0 0
19 Check pressure instruments with test equipment or by comparison 0 0
20
Check operation of cockpit heat controls, attachment of hoses and
valves
0 0
21 Inspect fuel valves and lines for operation, leaks and security
0 0 0
22 Check fire extinguisher for charge and security if installed 0 0 0
23 Check tail-wheel steering disengagement for proper operation 0 0 0
24
Check that all placards and instrument markings are present and
correct
0 0
25 Check for proper tow hook release operation if installed 0 0
26 Check ELT and battery IAW note 5 on page 10 0 0
27 OP/C over/under-volt system, warnings. 0 0
28 Check all ground operable circuits. Exercise all circuit breakers 0 0
38
Check insulators, controllers, instruments, displays, mics, headsets,
jackplugs and sockets
0 0
39
Check Instrument legibility and markings of ranges and limits and
consistent with ambient conditions
0 0
REV: F
RELEASED: 21 Jul 2017
PAGE 5 OF 12
WCAC FORM
SMWS