May 2, 2011
MAINTAINING THE JACE-700
Required NiMH Battery Maintenance
30
Part Number 11694 Rev 1.6
JACE-700
MOUNTING AND WIRING GUIDE
|
Figure 13 Replacing NiMH battery pack in JACE-700 controller.
Note
Dispose of the used NiMH battery properly.
Step 4
Unplug the NiMH battery from the main board connector (see
).
Step 5
Using a 1/4" (6mm) nutdriver, unfasten and retain the two kep nuts that
secure the metal battery bracket to the shield, and remove the shield and
battery pack.
Step 6
Put the
replacement battery
into the metal shield, and refasten back into
place on the shield, using the two kep nuts. Hand tighten with a nutdriver.
Step 7
Plug the battery connector plug of the replacement battery into the NiMH
battery connector on the main board of the controller. The connector is
keyed—you cannot plug the battery in reversed.
Step 8
Replace the cover.
Step 9
Restore power to the controller and verify normal operation.
Battery Disposal
Please dispose of the used NiMH battery in accordance with local, state, and federal
regulations.
Warning
Do not incinerate or mutilate the battery, as this may cause it to burst or
release toxic materials.
If regulations specify returning the old battery to a recycling center, but no
acceptable recycling center can be found, please return the old NiMH battery pack
to Tridium for proper disposal.
Cover removed
NiMH battery
connector on
controller board
NiMH battery pack
(NPB-J700-BATT)
Unplug/plug NiMH battery
from/to connector
1/4" (6mm) Kep nuts
(2) fasten battery
bracket to shield
Battery
bracket
