Vykon JACE-700, Инструкция по установке

Страница: 16 / 36

May 2, 2011 ABOUT EXPANSION OPTIONS
About Option Cards
16
Part Number 11694 Rev 1.6 JACE-700 MOUNTING AND WIRING GUIDE
|
1
Unlike with a JACE-2/6 controller with an NPB-MDM installed in slot 1, the onboard RS-232 COM1 port (DB9)
remains operational. Also, any NPB-MDM option is unaffected by the “mode jumper” position for serial shell
access (jumper in “serial shell” position affects the operation of the onboard RS-232 COM1 port only).
Option card COM port assignments
COM port assignments for option cards installed in the controller start at COM5,
with Slot 1 evaluated first, then Slot 2. (COM1 and COM2 are always assigned to the
onboard RS-232 and RS-485 ports, while COM3 and COM4 are reserved.)
Installing an Option Card
For option-specific details, see the mounting & wiring document that accompanies
the particular option card. The following procedure provides a basic set of steps.
Warning
Installing an option card in option Slot 2 requires careful atten-
tion—you must carefully
pry up the shield tab to install the option
card under the tab
. Do not install an option card in Slot 2 with the
card resting on top of the shield tab! Otherwise, an electrical short or
some other issue from misaligned card header pins may result.
Figure 6 JACE-700 option card and shield removal.
Procedure 2 Mounting an option card in a JACE-700 controller.
Step 1
Remove power
from the controller, including any external battery—see
the previous Warning on page 15.
Step 2 Remove the cover. See “Removing and Replacing the Cover,” page 13.
Step 3 Remove the blanking plate for the option slot, retaining the two screws.
Retain the blanking plate in case the option card must be removed later.
NPB-MDM 56Kbps Auto-dial/Auto-answer
Modem
1
with one RJ-11 connector
for phone line.
30-pin option card.
Does not have own UART (unlike most
other serial cards). Operates as COM5 if
installed in option slot 1, COM6 if in slot 2.
Table 2 JACE-700 controller option cards. (Continued)
Option Description Notes
Option Slot 1
Option Slot 2
Option card or
blanking plate in
Slot 1 must be
removed before
shield can be
removed.
Shield tab
Option card in Slot 2 must be
installed under the shield tab .
Shield with NiMH
battery assembly
Shield tab