Vykon JACE-700, Инструкция по установке

Страница: 23 / 36

WIRING DETAILS May 2, 2011
Power Wiring
|
JACE-700 MOUNTING AND WIRING GUIDE Part Number 11694 Rev 1.6
23
Figure 9 Adapting a WPM-XXX wall mount AC adapter to power the JACE-700.
After cutting off the WPM-
XXX
adapter’s end plug:
• If the coaxial type cable, carefully cut back the outer insulation, and gather the
outer shielded conductor (“–”) lead. Cut back about 5/16" (8mm) of the insulation
around the center shielded conductor (“+”) lead. See
Detail A
above. Terminate
the two leads into the 6-position end connector plug, as shown in Figure 9 , top .
• If the twin-lead type cable, carefully cut/separate lengthwise about 1" (25mm)
between the two leads, then strip back 5/16" (8mm) of the insulation around each
lead’s conductor. Terminate the two leads into the 6-position end connector plug,
as shown in
Figure 9 bottom .
Before plugging connector into controller, plug the WPM-
XXX
adapter into an
outlet and use a multimeter (on V DC) to verify correct polarity.
Do not power the controller until all other mounting and wiring is completed. See
“Power Up and Initial Checkout,” page 25.
+
-
15.1
V
DC
+
P
-
P
+
-
15.1
V
DC
+
P
-
P
Prior “twin lead” style adapter cable:
Positive (+) Wire with White Stripe
Cut off barrel plug
WPM- XXX
Check with multimeter before
plugging into controller
Newer “coaxial” style adapter cable:
Positive (+) Wire is Insulated Center Conductor
6-position
end
connector
plug
6-position end
connector plug
-OR-
Detail A:
Coaxial style adapter
cable stripped and
ready for termination