VSpeak ECU converter HORNET, Руководство пользователя, Страница: 16 / 18

ECU Converter HORNET Version: 1.1 www.VSpeak-modell.de
Page 16/18
2.4.3 Turbine-Status
AUTO Run
AUTO-HC
BURNER ON Pre Heat 1
CAL IDLE Learn LOW
CALIBRATE Learn HIGH
COOL-DOWN Slow Down
DEV.DELAY
EMERGENCY
FUELHEAT Pre Heat 2
FUELIGNIT Ignite
GO IDLE Stabilize
OFF Off
PROP IGNIT Ignite
RAMP DELAY Acceleration Delay
RAMP-UP Accelerate
SLOW DOWN SlowDown
STANDBY Wait for RPM
STEADY Accelerate
WAIT ACC Accelerate
2.5 HORNET 2 - Limitations
If you connect a HORNET 2 to the VSpeak ECU converter, there are some limitations:

There will be no values for fuel level, fuel flow and throttle transmitted. These values are set
to “0”. Thus no alarm can be generated for FUEL.

Battery and Pump Voltage are only refreshed, if the following symbols are on the HORNET
STATUS DISPLAY in front of the voltage.

Battery Voltage: , or

Pump Voltage
:
To display the turbine status there are various
preset messages in the radio. These do not
match the normal ECU messages 1:1, so the
closest match has been chosen. Please refer to
the table on the left.
For HORNET status messages without a
corresponding Spektrum message (grey fields
in the table) the last message is shown until a
new message, which can be translated, is
shown.