8
5
DEVICE INSTALLATION
5a
If necessary, cut device.
Cover Plate
Flush
Door
1
¹⁄₂
" (38 mm)
Recommended
Jamb
Jamb
Temporarily Remove
Anti-Rattle Clip
5b
If necessary, remove NL drive screw.
With the NL drive screw removed, key locks and unlocks lever, knob, or
thumb piece. For the trims listed below,
REMOVE
NL drive screw.
996L
696TP
990TP
996K
697TP
With the NL drive screw installed, key retracts latch bolt.
DO NOT
remove
NL drive screw for the following applications:
NL, EO, DT trims and 98/99-2 double cylinder devices (i.e. TP-2,
L-2, and K-2).
If the trim being installed is "BE" (i.e. 996L-BE), the trim lock tumbler
on the back of the device must be in the
UP
position before device
is installed. This allows the trim to be unlocked at all times.
*
*996L-BE
*996K-BE
*E996L
*E996L-BE
*696TP-BE
*697TP-BE
*990TP-BE
NL drive screw
Factory installed on
back of center case
Correct
Orientation
(RHR shown)
Incorrect
Orientation
trim lock
tumbler in
UP position
If necessary,
remove drive
screw and
rotate cam
until trim lock
tumbler is in
UP position,
then reinstall
drive screw
360˚
5c
Install lift finger(s) and retainer clip(s).
With device center case hanging over
edge of table, slide L-shaped lift finger
thru upper block of center case.
Insert
lift finger screw
and turn
clockwise with screwdriver to
raise lift finger until the slot aligns
with diameter of screw hole.
Lightly tighten
locking screw
(c-4).
Install retainer clip against lift finger,
snapping it into the slot of the
lift
finger screw
.
For 2-Point Latch Only
Repeat steps c-1 thru c-5 for lower block of center case.
Confirm
lift finger screw
is
free to rotate (c-5).
!
It may be necessary to rotate
the
lift finger screw
to realign
retainer clip and lift finger holes.
!
Top
c-1
c-6
c-2
slot
c-3
c-5
c-4
Bottom
