Volvo L45H 2016, Руководство оператора, Страница: 273 / 318

System test System test
In order to check the function of the greasing
system, or to initiate an extra lubrication cycle after,
e.g., the machine has been washed, a system test
can be run. The test button, which is used to begin
a system test, is positioned at the front on the pump.
A test cycle can only be run when the pump is
between two ordinary lubrication cycles (not during
an ongoing lubrication cycle).
Single test lubrication cycle Single test lubrication cycle
The pump only runs one lubrication cycle. one lubrication cycle.Can be Can be
used after washing to get extra lubrication. used after washing to get extra lubrication.
1 Turn the start key to position 1 (operating
position).
2 Press in the test button for 2–6 sec.
3 The lubrication cycle starts.
4 The test cycle ends automatically.
If If the the test test lubrication lubrication cycle cycle has has been been used to used to obtain obtain
an an additional additional lubrication lubrication cycle cycle after a after a wash, wash, the the test test
button button should should be be pressed pressed once once more to more to lubricate the lubricate the
other main line. other main line.
Continuous test lubrication cycle Continuous test lubrication cycle
The pump runs an unlimited number of lubrication an unlimited number of lubrication
cycles cycles, i.e., it continuously pumps out grease
alternating between both
bothmain lines. This This is is used for used for
bleeding air from the system. bleeding air from the system.
1 Turn the start key to position 1 (operating
position).
2 Press the test button for more than 6 sec.
3 The lubrication cycle starts.
4 End the test cycle by turning the ignition key to
position 0.
The test cycle does not end automatically.
The test cycle does not end automatically.
Test button
Maintenance Maintenance
Maintenance service, when required Maintenance service, when required 271 271
www. duma -rent.com