Volvo L45H 2016, Руководство оператора

Страница: 268 / 318

Removing tooth Removing tooth
1 Lower the bucket to the ground and angle it
slightly upward.
2 Clean the opening for tooth adapter's lock
device.
3 Drive out the lock device with a hammer and the
special tool or another suitable drift.
4 Remove the tooth.
Installing tooth Installing tooth
1 Clean the front part of the tooth adapter and the
hole for the lock device.
2 Install the tooth so that the guide lugs fit in the
tooth adapter's recesses.
3 Replace the lock retainer (B) with a new one.
4 Install the lock device so that the chamfered part
points down and the lock retainer points forward.
5 Drive down the lock device with a hammer until
it is level with the upper part of the tooth adapter.
6 Drive down the lock device further with a
hammer and the special tool or another suitable
drift until the upper part is just below the line
marking in the hole.
Replace the steel pin in connection with Replace the steel pin in connection with
replacement of tooth adapter.
replacement of tooth adapter.
Wheel bolts, checking tightening Wheel bolts, checking tightening
After having changed a tyre or if the wheel has been
removed and installed for any other reason, the
wheel nuts must be check-tightened after eight
hours of operation.
Tightening torque: 560–600 Nm (413–443 ft lb) Tightening torque: 560–600 Nm (413–443 ft lb)
Drive out the lock device
Lock device
A Steel pin
B Lock retainer
The lock device should be just below the
line marking.
266 266
Maintenance Maintenance
Maintenance service, when required Maintenance service, when required
www. duma -rent.com