Volpi Tecno Energia PAGURO 3000 compact, Руководство пользователя

Страница: 32 / 54

32
The benefits of a lower speed are less noise, less fuel consumption and an increased operative
engine life.
Main power 230 V (115 V)
As the most of the boats have installed 230 V (115 V) feeding line from the shore, it has to be
absolutely avoided that the main and the generator remain contemporaneously connected to the boat
plant.
A manual safety commutator (on request), or an automatic safety commutator (on request) has
to be provided.
Note: Both the lines or at least the generator line only, have to be protected with a magneto
thermic safety switch, fitted on the main board panel. For your
PAGURO choose a:
PAGURO 3000
COMPACT
PAGURO 3000 PAGURO 4000 PAGURO 5000
230 V 50 cyc. (A) 12 12 15 17
115 V 60 cyc. (A) /// /// 30 39
In any case at the engine grey box side it is located a safety switch on the main 230V that must
be considered as last additional protection if that on the board panel is out of order.
Electrical start
Note: All AC loads must be switched off before starting. This precaution will prevent damage
caused by unanticipated operation of AC machinery and will prevent a cold engine from
stalling.
This generator has a 12V DC electric starter. To start the generator , push the START button
on the control panel. The yellow start indicator light will come on and start to blink.
Once the engine fires and runs, the yellow start indicator light will go out the green run
indicator light will come on.
Note: If a start attempt is aborted, the yellow indicator light will continue to blink. To reset the
circuit, depress the stop button.
Apply a light load to the generator and allow the engine to warm up to operating temperature
before applying heavy loads.
Note: Some unstable running may occur in a cold engine. This condition should smooth out as
the engine warms up and when the generator loads are applied.