Vollrath STOELTING Flavor Burst STL-40SS-JR, Оборудование, техническое обслуживание и эксплуатация: Руководство

Страница: 61 / 74

58
Connecting the Unit Syrup Line
The syrup lines attached at the lower back of
the cabinet connect the four bags of syrup to
the Injector Assembly, with the fifth tube
connecting the sanitizer tank to the Injector
Assembly.
1. Locate the 5-Tube Lead at the back of the
cabinet. Remove the dust cap and slide the
coupler casing toward the unit to expose the
lead line coupler.
2. Remove the 9-hole gasket from the end of
the 9-Tube Assembly line. Spray the end of
the 9-Tube Assembly, the gasket, and the
end of the lead with sanitizer solution. Allow
these parts to sanitize for at least 5 minutes.
3. Align the 9-hole gasket with the coupler pins
of the 5-Tube Lead and place the gasket
against the coupler. Then align the coupler
pins of the two tube assemblies and
connect them.
4. Slide the coupler casing over the connection
and screw each coupler nut into each end of
the casing. Tighten the coupler nuts to
secure the connection.
Installing & Filling the Sanitizer Tank
For day-to-day operations, use Flo-San®
sanitizer mixed according to the manufacturer’s
instructions in the sanitizer tank. The tank
system delivers solution to specific areas of the
Flavor Burst
®
system such as the Injector Head
and syrup lines during certain
functions. Therefore, check the tank levels on a
daily basis. For proper sanitation, use only
FRESH sanitizer solution in the tank that is no
more than 28 days old. Replace older solution
with fresh sanitizer solution.
1. Insert one end of the sanitizer tube into the
fitting located at the lower back of the
cabinet.