Vollrath STOELTING Flavor Burst STL-40SS-JR, Оборудование, техническое обслуживание и эксплуатация: Руководство

Страница: 44 / 74

41
3. Brush and clean all exposed surfaces of the
Injector Head with detergent water. Use a
small brush to ensure that the syrup orifices
are clear of any residual syrup.
4. Submerge the Injector Head and the new
replacement o-rings in sanitizer solution and
soak for at least 5 minutes.
5. Remove the o-rings and Injector Head and
place them on a sanitary tray to dry.
6. Place the larger o-ring into the groove on
the underside of the Injector Head.
7. Apply food-grade lube to the two syrup port
o-rings and then place them into their
respective places inside the syrup port. A
small tool may be used to ensure the
o-rings are fully seated in the grooves.
NOTE: O-RINGS MUST BE COMPLETELY
SEATED TO PREVENT LEAKAGE.
Miscellaneous Cleaning Procedures
The following parts of the STL-40SS-JR do not
require daily cleaning. Inspect these areas
periodically and clean if necessary according to
instructions.
Prepare detergent water by mixing several
drops of Dawn
® dish soap with a gallon of
warm water (108°F / 42°C). Prepare sanitizer
solution by mixing half a packet (1 oz) of Stera-
Sheen® Green Label with one gallon of warm
water (108°F / 42°C) until dissolved. Pour
approximately 16 oz. of sanitizer solution into a
spray bottle and set aside the rest.
NOTE: DO NOT USE AN EXCESSIVE
AMOUNT OF WATER OR DETERGENT IN
CLEANING THE OUTSIDE OR INSIDE OF
THE CABINET.