Fig. 51
To program: Simultaneously press the buttons for the HomeLink Universal Transmitter and the remote
control.
¤
Please first read and note the introductory information and heed the WARNINGS
.
Getting ready to program
d
Please read the product manufacturer's instructions
before
programming the garage door opener
or other device.
d
Safely park the vehicle within range of the device to be programmed.
d
Switch the ignition on, but do not start the engine.
The buttons 1 , 2 , and 3 on the keypad in the sun visor can operate up to 3 separate devices (for
example, a gate and garage door, house alarm or lighting system).
Please carry out each step only in the order specified:
1.
For first time programming only
: Press and hold the two outer HomeLink buttons 1 and
3 at the same time for about 20 seconds, releasing only when the HomeLink indicator light
above button 2 begins to flash.
This step deletes any old settings.
Do not perform this step when programming the
additional HomeLink buttons.
2.
Position the hand-held transmitter for your remote control device 1-3 inches (25-75 mm)
away from the HomeLink keypad on the driver side sun visor, keeping the HomeLink indi-
cator light in view, as shown
⇒
fig. 50
.
3.
Using both hands, simultaneously press and hold both the HomeLink button you want to
program ( 1 , 2 , or 3 ) and the hand-held transmitter button, as shown
⇒
fig. 51
.
Do not
release the buttons until the HomeLink indicator light flashes slowly and then rapid-
ly.
When the indicator light flashes rapidly, release both buttons. The rapid flashing indi-
cates successful programming.
4.
Press and hold the programmed HomeLink button and watch the indicator light.
If the indicator light comes on and does not flash
, programming is complete and your
garage door opener or other device should activate when the HomeLink button is pressed
and released.
If the indicator light blinks rapidly
for 2 seconds and then stays on, proceed with the follow-
ing programming instructions for a rolling code device. A second person may make the
following steps quicker and easier. Please use a ladder or other device. Do not stand on
your vehicle to perform the next steps
⇒
.