Fig. 49
To program: Simultaneously press the buttons for the garage door opener and the remote control.
¤
Please first read and note the introductory information and heed the WARNINGS
.
Getting ready to program
d
Please read the product manufacturer's instructions
before
programming the garage door opener
or other device.
d
Safely park the vehicle within range of the device to be programmed.
d
Switch the ignition on, but do not start the engine.
The buttons 1 , 2 , and 3 on the keypad in the sun visor can operate up to 3 separate devices (for
example, a gate and garage door, house alarm or lighting system).
Please carry out each step only in the order specified:
1.
For first time programming only
: Press and hold the two outer garage door opener
buttons 1 and 3 at the same time for about 20 seconds, releasing only when the indicator
light in the keypad above button 2 begins to flash.
This step deletes any old settings.
Do not perform this step when programming the
additional garage door opener buttons.
2.
Position the hand-held transmitter for your remote control device 1-3 inches (25-75 mm)
away from the garage door opener keypad on the driver side sun visor, keeping the indica-
tor light above button 2 in view, as shown
⇒
fig. 48
.
3.
Using both hands, simultaneously press and hold both the garage door opener button on
the sun visor keypad you want to program ( 1 , 2 , or 3 ) and the hand-held transmitter
button, as shown
⇒
fig. 49
.
Do not release the buttons until the indicator light on the
sun visor keypad flashes slowly and then rapidly.
When the indicator light flashes
rapidly, release both buttons. The rapid flashing indicates successful programming.
4.
Press and hold the programmed garage door opener button on the sun visor keypad and
watch the indicator light.
If the indicator light comes on and does not flash
, programming is complete and your
garage door opener or other device should activate when the garage door opener button
on the sun visor keypad is pressed and released.
If the indicator light blinks rapidly
for 2 seconds and then stays on, proceed with the follow-
ing programming instructions for a rolling code device. A second person may make the
following steps quicker and easier. Please use a ladder or other device. Do not stand on
your vehicle to perform the next steps
⇒
.