Page | 12
11.
Set the desired anti-curl setting – suggested starting position 2 or 3, if the print curls up increase the number and if the
print curls down decrease the number. Gape the pull roller (11.1), pull the anti-curl handle out (11.2) and select number.
Lower pull roller (11.3).
Set the display anti-curl setting to match the mechanical setting (11.4).
12.
Set the guide wheel in the centre of the sheet (12.1). Set the perforator – ensure the perforator wheel is in line with the
film (up to 5mm) and within the media crop lines. Once aligned tighten the perforator into position using the black
handle (12.2), then turn the silver threaded thumb screw clockwise to lower the perforator wheel (12.3). Too much
pressure will perforate through the paper.
13.
Set the angle wheel on the edge of the print inline with the perforator and tighten the black handle (13.1) – set a small
amount of angle and tighten the top black handle (13.2). Different paper stock requires different pressure of the angle
wheel, this can be adjusted using the silver knurled knob (13.3), clockwise will increase the pressure.
11.1
11.2
11.3
11.4
12.1
12.2
12.3
13.1
13.2
13.3
