Page | 5
Safety Instructions
v
Please ensure that the voltages and phase of the power supply you are using match with the rated working voltages before
operating the system.
v
The power supply should be close to the system for convenient use.
v
The power supply should provide a reliable protective earthing connection.
v
This system must be earthed reliably as to ensure the safety of the system during operation.
v
Only the operators of this system should operate the electrical or mechanical components/controls.
v
Please don’t use damaged wires or sockets.
v
Please keep children away from touching or operating this system.
v
Please do not spray any liquids or cleaning products directly onto the system, this can cause a machine fault or electrical
shock.
v
During use please take care that no clothes, neckties, hair or jewellery etc are not overhanging near the system otherwise
injuries can occur.
v
Please don’t put burrs, sharp blades or thick rigid materials on, into or near any component especially rubber parts to
avoid damage.
v
Please shut down the system after laminating/foiling to avoid misuse.
v
At the end of each laminating /foiling job or the end of the working day always gape (lift up) the pneumatic rollers to
avoid flat spots and distortions of the rubber.
v
If the system needs to be moved, please turn of the power to the system and unplug from the socket.
v
Please be aware of the location of the wheels while moving the system as to avoid damage to any cables nearby and
personal injuries.
v
Always ensure the system is positioned on a flat and level floor.
v
Please be cautious of the foot pedal and cable position when operating or moving the system.
v
Only set the temperature to 80
o
C when first switched on as the temperature is designed to overshoot to maintain the heat
on the first run.
Environmental Requirements
v
Ambient room temperature 10
o
C – 60
o
C / 50
o
F – 140
O
F, humidity 30% - 80%, ideal humidity 55%.
v
Do not place the system below air conditioning units, drafts, external doorways and windows as this can affect the
accuracy of the temperature sensors.
v
Due to the static adherence of the film, you should keep the environment clean from dust. A dust cover is provided with
the system.
v
Please do not keep the system in direct sunlight.
v
Enough space should be kept around the system to ensure safe operation. The minimum holding areas are 2.5m x 3m/8ft
x 10ft.
