Page | 20
Troubleshooting
Anti-curl
If your sheet is curling upwards you need to increase the anti-curl and decrease if curling down. Too change the anti-curl setting
release the pressure on the pull roller, change setting and put the roller back down. Ensure the anti-curl mechanical setting
matches the display setting.
Sheet Separation
Ensure the perforator wheel is set over the laminating film within 5mm from the edge and anti-curl mechanical setting matches the
display setting. Depending on the media and material being used you might require both angle wheels, ensure the angle wheel on
the left is angled more than the one directly next to the perforator. If you have Pneumatic splitting pressure this might need to be
increased, for single sided is usually between 0.2-0.4psi and double sided between 0.4-0.6psi.
