19
Changes can be made without prior noticy. All rights reserved.
© Viscoo Enterprises Ltd. –
www.viscoo.nl
(
3) Set the time schedule (The specific settings are
found under the heading schedule recording
).
(4) Select sensitivity: The sensitivity for motion
detection is adjustable and the sensitivity is higher in
proportion as they increase the value of 1 to 5. When
the motion of the current channel is removed, the
system will jump in alarm and start recording. When
the sensitivity is low, such as "1" then the recording
will only start to major change. At "5", the system will
record all changes at small
image.
(5) Set the detection area:
Before you activate the motion detection, one would
have to determine the detection area. If the picture is changed in these areas, this is detected, and
enter the alarm state recorder. The yellow highlighted area to detect the field
.
-
The area set with the remote control is done by using a directional keys to set the startpoint
and the endpoint. Press the confirm button to save your settings. Left Mouse Click to view
the status of the motion detection area to be set. Then you press the return / previous to the
recording settings without saving or you press save / save the settings to activate
.
-
The area set with the mouse: left click with the mouse for the starting position of the area to
be determined, then click another point to determain the end point. Then the selected area
is shown. Double click left to delete the selection. Then you press the return / previous to the
recording settings without saving or you press save / save the settings to activate
.
(6)
Alarm Output Setup: The button will turn yellow when the alarm output function is activated with
deactivation the button is gray.
2.
Video loss alarm
By default, the DVR is set when a signal interruption occurs, an alarm buzzer is activated. There are 3
ways to set an alarm output, these are audio buzzer and full screen. You can click on information to
see the emergency status.
4.5.2 Alarm Sensor setup
The following steps should be performed to setup a sensor
:
(1)
After logging in, one goes to "main menu" then "Record Setup" and then go for "record
parameter" for the settings interface to open the alarm recording, set the corresponding channel,
pre-recording and the recording time
.
(2)
Select "Main Menu" then "Alarm setup" and then "sensor", open interface for alarm recording,
the interface looks like this
.
(3) Choose sensor type.
(4) Choose sensor number.
(5)
Set the active period (the specifics can be found under the piece of chart settings). Left Mouse to
set the start and then drag the mouse to the endpoint
.
(6)
The recording channel can be linked to an alarm, we recommend that each channel corresponds
to a sensor, so the alarm recording files can be found by channel. A yellow button means that there is
a link for alarm recording, a gray button means there is no link.
(7)
Alarm output settings: you can select the alarm output button. (Yellow is on, gray is off).
The system supports a recall to a preset point function when an alarm is triggered. (it is a
requirement that the camera supports preset). The settings you make as follows:
1.
Click "PTZ preset point" to PTZ preset interface bands, there you can set the preset point.
(Note: the range for a PTZ preset is 1-255, 255 means close. If you copy the channel settings,
the settings are not copied along with it!) after this one should save to save the data.
