1.
Open the front flap of your I/O module.
2.
Bring the front connector in cabling position.
For this you plug the front connector on the module until it locks.
In this position the front connector juts out of the module and
has no contact yet.
3.
De-isolate your wires. If needed, use core end cases.
4.
Thread the included cable binder into the front connector.
5.
If you want to lead out your cables from the bottom of the
module, start with the cabling from bottom to top, res. from top
to bottom, if the cables should be led out at the top.
6.
Bolt also the connection screws of not cabled screw clamps.
7.
Fix the cable binder for the cable bundle.
8.
Push the release key at the front connector on the upper side of
the module and at the same time push the front connector into
the module until it locks.
9.
Now the front connector is electrically connected with your
module.
10.
Close the front flap.
11.
Fill out the labeling strip to mark the single channels and push
the strip into the front flap.
20pole screw connec-
tion 392-1AJ00
VIPA System 300S CPU
Assembly and installation guidelines
Cabling
HB140 | CPU | 315-2AG13 | GB | Rev. 14-40
21
