Viking DFUW244CL, Руководство по обслуживанию

Страница: 31 / 87

5.1 Accessing the Mechanical Base-Plate
Access to the mechanical base-plate is located at the rear of the unit. Most mechanical and electrical compo-
nents on the unit mount directly to the base-plate.
To gain access to the mechanical base-plate proceed as follows, be sure to reference the photos as called out.
Step 1: Remove all screws around the perimeter of the cabinet. Do not remove the screws from the slotted area.
(See figure 12.3)
Step 2: To loosen the rear of the mechanical assembly, remove both hex screws at each lower back corner (See
figures 12.4).
Step 3: Remove the two Phillips screws and remove the front grille (See figure 12.5).
Step 4:To loosen the front of the mechanical assembly, remove both Phillips screws that secure the front corners
(See figure 12.6).
Step 5:
CAUTION , (See figures 12.7 & 12.8) before sliding out the mechanical assembly please read the fol-
lowing carefully. To avoid kinking of any system tubing do not slide the mechanical section forward far-
ther then 6” maximum. Doing so may kink any or all of the following: discharge line at the compressor,
suction line at the compressor, suction line as it exits the rear of the cabinet.
SEE PHOTO SECTION FOR REFERENCE TO ABOVE MENTIONED FIGURES
26
Mechanical
baseplate
2010 - Viking Preferred Service SMR-0005