Viking DFUW244CL, Руководство по обслуживанию

Страница: 39 / 87

6.1 Divider Assembly & Evaporator Cover
The divider of the dual zone wine cellar separates the upper and lower compartments. The return air
for the lower compartment is directed through a return air damper located on the bottom of the divider.
Return air is then diverted through the rear of the divider assembly and into the return air compartment
of the evaporator section.
The return air damper is automatically drawn open when that compartment fan is running. The damper
door consists of a Mylar material that is taped into position and simply opens when air is drawn through
it when the compartment fan is running.
The power supply for the lower compartment light is also run through the rear, right hand corner of the
divider assembly.
6.1.1 Removal of the Divider & Evaporator Cover
Step 1: Remove all shelving.
Step 2: Remove the 2 screws that secure the divider to the sidewall channel rails. These screws are
located on the front edge of the divider bottom (See figure 12.18). Do not remove the screws
located closest to the front as these hold the divider assembly together.
Step 3: Pull divider assembly out approximately 2-3 inches, just enough to disconnect the white Molex
connector located behind the divider at the right hand corner (See figure 12.19). The Molex
connector has a release clip on each side of the plug. Using the thumb and forefinger, simply
press the release towards the body of the plug and gently pull back and away from the connec-
tion.
Step 4: Slide divider assembly out and remove.
Step 5: Remove screws that secure the channel rails on the left and right hand sides of liner (See figure
12.20).
Step 6: Disconnect the two Molex connectors located in the top left corner of the upper compartment
(See figure 12.21). Use the method in Step 3 to release plug.
Step 7: (See figure 12.21) Locate the Molex connecter (second from the left hand side) that is still at
tached to the evaporator cover. Place the flat of your thumb over the plug and apply pressure to
push the connector back behind the evaporator cover.
Step 8: Disconnect the Molex connector located in the top left corner of the lower compartment (See
figure 12.22). Release the clip using the same method as before.
Step 9: Remove the 6 push plugs that hold the evaporator cover in place (See figure 12.23). This can be
done with a pair of pliers or channel locks. Grasp the head of the nut with the pliers and pull
outward, take some care as these plugs can be reused.
Step 10: Both supply fans need to be disconnected before the evaporator cover can be removed. To
accomplish this bring the left hand side of the evaporator cover forward and reach behind the
cover to disconnect the Molex connections to both fans (See figure 12.24). Use the same method
previously mentioned to disconnect Molex plugs.
Step 11: Remove cover. You now have access to the evaporator assembly (See figure 12.25).
SEE PHOTO SECTION FOR REFERENCE TO ABOVE MENTIONED FIGURES
34
2010 - Viking Preferred Service SMR-0005