Viking DFUW244CL, Руководство по обслуживанию

Страница: 41 / 87

6.2 Door Handle
To remove, adjust, or tighten the door handle use a 3/32” allen wrench to either tighten or loosen the two
(2) set screws that secure the handle at the top and bottom stand-offs (See figure 12.28). If removing the
handle and stand-offs completely the truss head screws inside the stand-offs will have to be removed
using a Phillips screwdriver (See figure 12.29).
6.3 Door Hinge Adjustment
The cabinet and door components that are related to the top and bottom of the door are: (2) hinges, (2)
hinge adaptors, (2) hinge pins, (2) nylon bushings, (4) ¼-20 screws, and (6) 10-32 counter sunk screws.
To adjust the door:
Use a 5/32” allen wrench to loosen the two (2) ¼-20 screws securing the door adaptor to the top of the
door (See figure 12.32). Once loosened, the height of the door can be adjusted. Align the top of the door
so that it appears parallel to the cabinet top. Tighten the ¼-20 screws.
Note: The top of the door will not set as high as the top of the cabinet, but it will appear that both cabinet
and door are aligned the same.
6.4 Leveling Legs
There are a total of four (4) leveling legs, one on each bottom corner of the cabinet.
Lift each corner separately to adjust individual legs. The bottom of each leg is hex shaped so that an
adjustable wrench or channel-lock pliers could be used if necessary to adjust height. Leveling legs on a
new unit are finger tight and can be adjusted without the use of a tool.
Turning the leveling legs clockwise will raise the height while counter-clockwise will lower the
adjustment.
It is recommended placing a bubble level on the cabinet top to check for side to side and front to back
levelness.
36
2010 - Viking Preferred Service SMR-0005