Viking DFUW244CL, Руководство по обслуживанию

Страница: 65 / 87

60
PROBLEM POSSIBLE CAUSE CORRECTION
Unit does not operate Unit is unplugged
ON/OFF keypad was not held long
enough on display
Plug in the unit
Press ON/OFF keypad for 5 seconds
Unable to set desired
compartment set-points.
SET keypad was not depressed while using the
WARMER and COLDER keypad to find desired
point.
Press the SET keypad, audible beep will sound. Press
the WARMER or COLDER keypad to reach the desired
set-point. An audible beep will sound at each keypad
function.
Display lighting doesn’t work.
Keypad function not activated.
Light bulb is burned out.
Press the LIGHT keypad, audible beep will sound and a
blue light will appear on keypad. The light with stay lit
when the door is closed.
Replace bulb and keypress light keypad.
Door is closed but the light is still on. Display lighting is on.
Door magnet is not activating reed switch
Turn off display lighting.
Align or space door magnet closer to reed switch.
Cannot activate Show Room Mode ON/OFF keypad was not held during power on
reset. (P-O-R).
Hold ON/OFF keypad firmly while unplugging unit
momentarily before plugging back into recepticle (P-O-
R)
Interior lights functioning but compres
-
sor, condenser fan, compartment fans and
heater/fans are disabled
Show Room Mode is enabled.
Hold ON/OFF keypad firmly while unplugging unit
momentarily before plugging back into receptacle (P-O-
R)
Sabbath Mode is not engaging
Set keypad was not depressed and held firmly
while pressing the WARMER keypad 4 times
within 7 seconds.
Depress and hold SET keypad firmly while press-
ing the WARMER keypad 4 times within 7 seconds.
Audible beep will sound at every key stroke
Sabbath Mode is not disabling.
Set keypad was not depressed and held firmly
while pressing the WARMER keypad 4 times
within 7 seconds.
Depress and hold SET keypad firmly while press-
ing the WARMER keypad 4 times within 7 seconds.
Audible beep will sound at every key stroke
Sabbath Mode is automatically disabled. Sabbath Mode automatically disables after 72
hours.
Reset Sabbath Mode as mentioned above.
Alarm sounds 3 times every 30 seconds. Door magnet is not activating reed switch. Close door.
Adjust door magnet to close reed switch.
Alarm sounds 6 times every minute. High or low temperature alarm. Check compartment diagnostics below.
Message center displays Power Failure.
This is normal at initial start up - power to unit
was disrupted after factory quality test.
Loss of power to electrical circuit or home.
Press ON/OFF keypad once to reset.
Press ON/OFF keypad once to reset.
E1 error code along with audible alarm (6 /
per min.) - Compressor high/low amps
Compressor wire disconnected.
Faulty compressor.
Faulty Power Board
Faulty overload
Faulty PTC relay
Power surge Check wiring.
Check winding resistance- replace if necessary
Replace board.
Ohm and replace if necessary
Ohm and replace if necessary.
Reset alarm.
11.1 Problem / Cause / Correction
2010 - Viking Preferred Service SMR-0005