Viking DFUW244CL, Руководство по обслуживанию

Страница: 40 / 87

6.1.2 Installation of the Divider & Evaporator Cover
Step 1: Re-assemble by reversing the above steps
Step 2: Before re-installing the divider make sure that the back edge of the assembly has a small piece of
tape (between each corner and return air channel) to hold the assembly together (See figure
12.26). This will aid when re-installing into the rear channel. The tape should not extend any far-
ther out then 3/16” on the upper and lower divider panels. NOTE: make sure that the return air
channel on the back of the divider is not restricted or covered with the tape
Step 3: When re-installing the divider it is pertinent that the divider is sandwiched between both the side
and rear channel rails. This is necessary to obtain proper assembly and to obtain proper perfor-
mance of the wine cellar. A putty knife with a 6” blade will help the assembly process by insert-
ing it between the rear divider surface and the inside of the back channel flange. Gradually work
the knife along the back edge while sliding the divider in place (See figure 12.27). This can be
achieved by rotating this process between the top and bottom edges of the divider until it is clear
of any binding and rests securely inside the back of the rear channel.
SEE PHOTO SECTION FOR REFERENCE TO ABOVE MENTIONED FIGURES
35
2010 - Viking Preferred Service SMR-0005