Viking DFUW244CL, Руководство по обслуживанию

Страница: 12 / 87

It is also important to note that although the inside temperatures of the wine cellar may vary a few de
-
grees that stored product will not be effected by small amounts of temperature change due to their mass.
2.1.5 Setting the Display Temperature
To adjust the set-point temperature, press the “Set” keypad once. The user interface board will beep once
and a “set” icon will appear in the upper compartment display. Once in the Set Mode use the “Warmer”
and “Colder” keypads to obtain the desired point.
To adjust the lower compartment press the “Set” keypad a second time. Again, there will be an audible
beep and the “set” icon will appear in the lower compartment display. Exit the “Set” Mode by using
either one of two methods: The first would be to press the “Set” keypad a third time, once again the au-
dible alarm will sound and the user interface will return to display mode. The second method is to let the
Set Mode “time out” after five (5) seconds of no keypad activity and return back to display mode.
2.1.6 Select Fahrenheit (˚F) or Centigrade (˚C)
The display temperature can be changed from Fahrenheit to Centigrade by pressing the ˚F/˚C keypad
one time. An audible beep will sound with every keypad function.
2.1.7 Display Lighting
There are two interior lights located inside the wine cellar. Each compartment has its own dedicated
bulb. The normal operation is that the light bulbs turn on as the door is opened and off when the door is
closed.
The display lighting can be enabled by pressing the light keypad once. An audible alarm will sound
when activated and the light keypad will display a blue LED. Display lighting will stay on continuously.
2.1.8 Show Room Mode
Show room lighting is activated by pressing and holding the “On/Off” keypad simultaneous of perform
-
ing a P-O-R (Power-on-Reset). P-O-R is defined as momentarily interrupting power to the unit. This can
be accomplished by simply unplugging and plugging the unit back into the receptacle. Remember to
press and hold the the “On/Off” keypad at the same time as the P-O-R.
The compressor, condenser fan, compartment fans, heater/fans, and alarms are disabled during this
mode. The following functions will remain enabled: the display showing the last set-points, the “On”
icon in the message center, key tones, internal lights, set keypad, warmer/colder keypad, mode keypad,
light keypad, and the F/C keypad.
When the P-O-R has been preformed, press the light keypad, an audible beep will sound, and the blue
LED on the light keypad will turn on.
The compartment lights will remain on for a maximum of 15 minutes. After 15 minutes the compartment
lights will time-out and shut off. However the blue LED light on the
7
2010 - Viking Preferred Service SMR-0005