9.
Add recommended hydraulic oil to no
higher than 1/2 inch/13 mm from the top
of the tank. Refer to the “Recommended
Lubricants” table for the proper hydraulic
oil. Re-install the hydraulic breather cap on
top of the hydraulic tank.
10.
Set the depth adjuster lock on the tool to
obtain a ¼-inch/6-mm gap between the
depth adjuster lock and the tool body.
11.
Set the selector valve on the front of the
tool to the
“BLACK”
setting.
12.
Turn the selector switch on the side of the
tool to the “NORMAL” position.
WARNING
• The lower roll will rotate when the safety
foot switch is depressed.
• Avoid contact with the lower roll as it
rotates.
Failure to follow these instructions could
result in serious personal injury.
13.
Depress and hold down the safety foot
switch, and observe the movement of the
hydraulic ram. The hydraulic ram should move
down ¼ inch/6 mm rapidly. Release the safety
foot switch. The hydraulic ram should return
to its full up posi tion. Repeat this procedure
several times.
14.
Set the selector valve on the front of the
tool to the “
RED
” position, and repeat Step
13.
15.
If the slide does not move rapidly in the
downward direction, repeat Steps 2 to 14.
TM-VE268_42
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
