ARBOR REMOVAL FOR 2-INCH/60.3-MM
AND LARGER SIZES
1.
Remove the lower roll from the tool by
referring to the “Lower Roll Removal for
2-inch/60.3-mm and Larger Sizes” section.
2.
With a wrench engaged on the cap screw
portion of the stud, loosen the stud by
turning
counterclockwise
. The arbor
should move outward as the stud is
loosened.
3.
When the stud has stopped moving the
arbor outward, pull the arbor assem bly out
of the tool’s main shaft. Store the arbor
assembly in the tool cabinet.
NOTICE
• The arbor could become difficult to
remove from the main shaft if insufficient
lubrication was applied. The arbor
features three 1/4 – 20 UNC tapped holes
so that jack bolts can be used to push out
the arbor.
CAUTION
• Never operate the tool with jack bolts
installed in the arbor.
Failure to follow this instruction could result
in personal injury and tool damage.
UPPER ROLL REMOVAL – ALL SIZES
1.
Using a wrench, loosen and remove the
upper roll bolt. Place the upper roll bolt in
a safe location.
2.
Remove the upper roll assembly by pulling
it straight out of the tool. Store the upper
roll assembly in the tool cabinet.
TM-VE268_33
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
